Avaya Aura(TM) Communication Manager and CM Messaging (R6.0) Implementation 6002-1 Prüfungsfragen mit Lösungen:
1. Through which protocols can integration of communication manager messaging application
6.0 with communication manager occur? (Choose two)
A) SIP protocol
B) RTP protocol
C) SSP protocol
D) H.323/Q. Sig protocol
2. A technician wants to test and see if the voice channel between two IP phones
Which command in site administration terminal (SAT) can be used to determine?
A) List station <extension>
B) Status shuffling <extension>
C) Test station <extension>
D) Status station <extension>
3. Which MAC address is recommended for the license file?
A) The MAC address of the Console domain
B) The MAC address of the CM host name
C) The MAC address of the CM eth0 port
D) The MAC address of the DOM0
4. A user at a remote branch location is registered to a G450 media Gateway connected via processor Ethernet (PE) to a main communication manager in the core. The report that they are no longer able to place calls to users at the core
Which three procedures can be used to diagnose the source of problem? (Choose three)
A) Confirm that the registered field on the communication Manager Display media-gateway to Y.
B) Use the list registered -IP-station command on the communication manager to determine whether the user on the media gateway is registered.
C) Use the list survivable processor command to confirm that the survivable server is registered to the main communication manager.
D) Conform that the PE interface is active by executing the communication manager display processor Ethernet command and confirm that the allow H.248 Gateway field is set to Y.
E) Use the show MGC command on the media gateway to confirm the IP address of the PE enabled server at the core is administered as the primary controller of the media gateway.
5. A customer has a communication Manager R6.0 system with IP phones and some older TDM phone, and says there is no dial tone for all of the IP phones. All of the hardware has been verified to be working properly.
Which two steps can be taken to identify the cause of problem? (Choose two)]
A) Verify that the TN2602 Media resources circuit pack has the correct IP settings.
B) Set a static IP address on a laptop and see if the server can be pined
C) Verify that the processor Ethernet mode is enabled in the Server.
D) Set a static IP address on a laptop and see if the TN2602 Media Resource circuit pack can be pinged.
Fragen und Antworten:
| 1. Frage Antwort: A,D | 2. Frage Antwort: D | 3. Frage Antwort: C | 4. Frage Antwort: A,B,C | 5. Frage Antwort: A,D |
1024 Kundenbewertungen
