IBM 000-109 Prüfungsthemen:

IBM Virtualization Technical Support for AIX and Linux - v2 000-109 Prüfungsfragen mit Lösungen

Frage #1

A VIO server provides a virtual Fibre Channel adapter to each of 2 LPARs. The HBA has recently been replaced on the VIO server. After the VIO server was rebooted, the clients LPARs were also rebooted. The LUNs are now showing as "Defined" instead of "Available". What is the cause?

A. The client virtual Fibre Channel adapters were configured via DLPAR.
B. The HBA created new WWPNs on the virtual Fibre Channel adapters.
C. The HBA requires an initial configuration to be performed.
D. The client virtual Fibre Channel needs a map to the new WWPNs.

Frage #2

A Power Systems server has two HMCs connected to its Flexible Service Processor (FSP). It is decided to upgrade one of them to a later hardware version. The 7042-CR3 is disconnected and the new 7042-CR6 is connected in its place. The new HMC successfully discovers the managed server but some operations including DLPAR are failing.
Which action will allow the managed server and HMC to establish new RMC configurations?

A. Use the "Reset Or Remove Connection" panel on the HM
B. Run "/usr/sbin/rsct/install/bin/recfgct" in each LPAR.
C. Run "refresh -s IBM DRM" in each LPAR
D. Reset the RMC connection in the Console menu option in ASMI

Frage #3

When many LPARs require large quantities of SAN LUNs, what is a benefit of leveraging NPIV over more traditional vSCSI virtualization?

A. Reduced administration
B. Multipath I/O
C. Normalized throughput
D. Enhanced resilience

Frage #4

An administrator has removed a client LPAR and would like to unmap the virtual Fibre Channel adapter vfchost0 from the physical backing adapter fcs2.
Which of the following commands will achieve this?

A. vfcmap -vadapter vfchost0 -fcp
B. rmdev -dev fcs2
C. vfcumap -vdev vfchost0 -dev fcs2
D. rmvdev -vtd vfchost0

Frage #5

A Linux LPAR is configured using 802.1Q.
The virtual Ethernet device is configured as an 802.1Q compatible adapter and has VLAN
ID 5 configured in the 802.1Q additional VLAN field.
The administrator runs the following commands on the Linux LPAR shell without errors:
vconfig add eth0 5ifconfig eth0 10.0.0.2 netmask 255.255.255.0
When the administrator tries to ping 10.0.0.1, the request times out.
What is the problem?

A. The VLAN ID should be in the VLAN-ID field in the virtual Network device configuration.
B. The 8021q module is not loaded.
C. The administrator is using the incorrect Ethernet device.
D. The 802.1Q interfaces are not supported on Linux on Power Systems servers.

Fragen und Antworten: